How to stripe a wall

Print
Email
|

by Debbie Hernandez, The Home Depot / Special to azfamily.com

azfamily.com

Posted on December 11, 2012 at 12:35 PM

Updated Tuesday, Dec 11 at 12:40 PM

Materials

  • Paint
  • Blue Painters Tape
  • Tape Measure
  • Paint Brush (high quality)
  • 6" Mini Roller and Handle
  • Pencil
  • Chalk Line (optional)
  • Level (optional)

Instructions
Plan your project.

Decide where, accent wall, guest bath, lower half of a wall as wainscoting, etc.

Select paint colors to coordinate with the flooring, fabrics, furnishings, counter-tops, etc. You'll need at least two colors.

Preparation
Tape off ceilings, baseboards, door trim and perimeter areas.

Cover counters, mirrors, floors, etc. for protective purposes. Paint the lighter of your two colors as the base coat; prime first if needed.

Paint stripes
After base coat is thoroughly dry, measure walls side to side and determine width of stripes. Common widths range from 4 inches to 10 inches.

Smaller walls or rooms use smaller stripes. The average stripe width 6 to 8 inches.

Mark walls at top and bottom. Tape from mark at the top to mark at the bottom inside every other stripe. This will ensure all even stripes

Secure the tape from the top mark. If you pull the tape out from the wall then back in at the bottom mark, it will automatically create a straight line.

Seal tape on the edge facing inside to the stripe that will be painted with the BASE COAT color.

Anything that will seep through and penetrate under the tape will match the base color, this will create razor-sharp lines.

Let dry.

Paint darker stripe color. Apply a second coat if needed.

Peel away tape while paint is wet or still tacky.

Adorn with nail heads, a secondary stripe color, jewels or just leave as is.


You can find Debbie Hernandez at the Home Depot located at Arrowhead, off the Loop 101 and 59th Avenue. For more information or to find a location near you, visit HomeDepot.com.

Print
Email
|